33.5.4 Synchronizing graphics settings for RTF output

For RTF output types, check configuration settings for the following options; their values must reflect the destination, not the origin, of graphics to be copied to the WrapPath folder:

[Graphics]

; FileNames = Retain (default) or Map (in the GraphFiles section)

; FilePaths (for graphics) = Retain (default) or None (strip off)

[GraphFiles]

; types to map, replace extension, old=new for referenced graphics

; specific filenames to replace, old = new, overrides type setting

If WrapPath points to the project folder:

• Set FileNames=Map

• Set FilePaths=None

• Make sure [GraphFiles] entries do not include paths.

If WrapPath points to any folder other than the project folder:

• Set FileNames=Map

• Set FilePaths=Retain

• Make sure any paths in [GraphFiles] entries point to the WrapPath folder.

See §Table 29-1 RTF replacement graphics file mappings and locations.

See also:

§29.3 Replacing and relocating graphics files.

---

> 33 Producing deliverable results > 33.5 Placing graphics files for distribution > 33.5.4 Synchronizing graphics settings for RTF output