36.2.2 Setting up a FrameMaker MIF project

When you select FrameMaker MIF as the output format for a new project, the Set Up dialog shown in Figure 36-1 opens. Table 36-1 shows the corresponding settings in the configuration file.

See also:

§3.4 Choosing project set-up options

Figure 36-1 Set Up FrameMaker MIF Project

Table 36-1 FrameMaker MIF set-up options and configuration settings

Set-up dialog	Configuration file
Option	Section	Setting	Default	Ref.
Make MIF for book file	[FDK]	MakeBookMIF=Yes	Yes	36.2.4
Use original extensions for MIF	[FDK]	OrigExtForMIF=Yes	Yes	36.2.7
Use following extensions: For MIF file(s) For book file	[FDK]	OrigExtForMIF=No MIFSuffix=.any MIFBookSuffix=.any	Yes .mif .mif	36.2.7

 

Note:

When you click OK to dismiss the FrameMaker MIF Set Up dialog, and Notepad opens to show configuration settings based on your choices, do not be alarmed if you see settings that purport to make both file extensions .mif, even though you specified original extensions. A later setting overrides the earlier settings.

---

> 36 Generating MIF or ASCII DCL output > 36.2 Generating MIF output > 36.2.2 Setting up a FrameMaker MIF project